|
Brass Inserts: We can
install most any inch or metric Brass insert such as 1/4-20 and M6 or M8.
POBCO's standard size is 5/16-18 thread to accommodate our Standard S.S.
Support Rods.
Brass inserts work best with Stainless Steel Support
Rods.
Brass Inserts and Stud Bolts
can be purchased separately. (Stainless Steel Available)
| Part
Numbers: |
# BI
5/16-18 |
# BI
1/4-20 |
# BI
M6 |
# BI
M8 |
| Part
Number: |
# SB
5/16-18 |
| 1. |
Determine
number of supports along 10 FT. Guide Rail. ( 12 - 20"between supports is
common) |
| 2. |
Drill round
holes in desired support locations. |
| 3. |
Press into
holes Brass Expansion Inserts. |
| 4. |
Screw 1 5/8
Stud Bolt into the Support Rod. Then Screw the Support Rod into Brass Insert
until tight and flush against the plastic Guide Rail. The brass insert will
expand and tighten during this installation. |
| Material |
Thread |
1/2" Support
Rod |
| 4"
Long |
6"
Long |
10"
Long |
16"
Long |
| Stainless Steel |
5/16" - 18 |
SSR0518L4 |
SSR0518L6 |
SSR0518L10 |
SSR0518L16 |
| Stainless Steel |
3/8" - 16 |
SSR0316L4 |
SSR0316L6 |
SSR0316L10 |
SSR0316L16 |
| 1/2" Support
Rod |
| Stainless Steel |
5/16" - 18 |
SSR051810L4 |
SSR051810L6 |
SSR051810L10 |
SSR051810L16 |
| Stainless Steel |
3/8" - 16 |
SSR031610L4 |
SSR031610L6 |
SSR031610L10 |
SSR031610L16 |
NOTE:
· Shafts with 5/16" - 18 Thread are used
with CSS-2424 Clamp (See pg. 12)
· Shafts with 3/6" - 16 Thread are used
with CSS-Double & CSS-Triple Clamp (See pg.
12)
· See clip selection
on page 11
Use your back button to return to
this page. |
|
