Brass Inserts: We can
install most any inch or metric Brass insert such as 1/4-20 and M6 or M8.
POBCO's standard size is 5/16-18 thread to accommodate our Standard S.S.
Support Rods.
Brass inserts work best with Stainless Steel Support
Rods.
Brass Inserts and Stud Bolts
can be purchased separately. (Stainless Steel Available)
Brass
Inserts
Part
Numbers:
# BI
5/16-18
# BI
1/4-20
# BI
M6
# BI
M8
Stud
Bolt
Part
Number:
# SB
5/16-18
Attaching
Instructions:
1.
Determine
number of supports along 10 FT. Guide Rail. ( 12 - 20"between supports is
common)
2.
Drill round
holes in desired support locations.
3.
Press into
holes Brass Expansion Inserts.
4.
Screw 1 5/8
Stud Bolt into the Support Rod. Then Screw the Support Rod into Brass Insert
until tight and flush against the plastic Guide Rail. The brass insert will
expand and tighten during this installation.
Material
Thread
1/2" Support
Rod
4"
Long
6"
Long
10"
Long
16"
Long
Stainless Steel
5/16" - 18
SSR0518L4
SSR0518L6
SSR0518L10
SSR0518L16
Stainless Steel
3/8" - 16
SSR0316L4
SSR0316L6
SSR0316L10
SSR0316L16
5/8" Support
Rod
Stainless Steel
5/16" - 18
SSR051810L4
SSR051810L6
SSR051810L10
SSR051810L16
Stainless Steel
3/8" - 16
SSR031610L4
SSR031610L6
SSR031610L10
SSR031610L16
NOTE: · Shafts with 5/16" - 18 Thread are used
with CSS-2424 Clamp (See pg. 12) · Shafts with 3/6" - 16 Thread are used
with CSS-Double & CSS-Triple Clamp (See pg.
12) · See clip selection
on page 11 Use your back button to return to
this page.
Pivot End Adjusting Rods are made of 303
stainless steel. The jointed ends have an
internal thread of 5/16-18 and allow for
POBCO clips or threaded bolts. Pivot ends
allow these rods to support rails around
curves and bends of conveyor systems.