POBCO Ultra-D Flight Edging is used to snap-on over the screw conveyor flight to extend the life of the flight and to allow for improved clean-out of the trough. It is normally installed by winding it along the screw so that it snaps on in the well between the flights and secured with metal rivets. Starting at one end the UHMW plastic is tapped into place by moving along the length of the screw. This Ultra-D plastic is stabilized against ultra-violet light radiation. The center bearing on short conveyors can sometimes be eliminated when the center of the screw sits lightly in the trough.

• UV Stabilized For Outdoor Use
• Improve Clean-Out Of Troughs
• Eliminate Hangers On Shorter Runs
• Use With Helicoid Or Sectional Flights
• Reduce Noise And Wear On Rubbing Screws